Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame-relay switching using 2 routers

I have 2 t1 CSU/DSU WIC card in cisco2800 and cisco2651 XM. This is my fisrt time doing this. Can you please specify which cable exactly I shd use:

Frame-relay switching is enbaled on both routers globally...

below is my config

interface Serial0/0

description FR switch

no ip address

encapsulation frame-relay

no keepalive

no fair-queue

frame-relay interface-dlci 201

!

interface Serial0/0.21 point-to-point

ip address 131.1.12.2 255.255.255.0

frame-relay interface-dlci 201

interface Serial0/3/0

description FR switch

no ip address

encapsulation frame-relay

no keepalive

frame-relay lmi-type cisco

frame-relay intf-type dce

!

interface Serial0/3/0.12 point-to-point

ip address 131.1.1.1 255.255.255.0

frame-relay interface-dlci 101

3 REPLIES
Silver

Re: Frame-relay switching using 2 routers

New Member

Re: Frame-relay switching using 2 routers

Thanks for your help.

The interface is still down. I am using a xover cable between both router and it is till not working....

Silver

Re: Frame-relay switching using 2 routers

Which csu/dsu are you using? Did you configure the controller correctly?

I suggest you tray to get the T1 link working first and then change encapsulation to FR.

320
Views
0
Helpful
3
Replies