does anyone have a proven method for bonding two T1s together to provide a cumulative pipe of 3Mb.."which" will appear as one logical connection, thus eliminating the asymmetrical routing issues associated with seperate T1s on the same router? Please guide me in the right direction if you've any experience with this type of scenario. Thanks in advance!
The most efficient way to utilize both your T1s is by bonding them with a feature called Multilink PPP over frame relay. Bonding happens at layer 2 with this feature and therefore you need not worry about assymetrical routing problems with the T1s. All your layer 3 configuration is done on a single multilink interface.
There are plenty of resources available on CCO on this topic and configuration documents. Here's a couple that you may find helpful.
Using Multilink PPP to bond Frame-relay T1's isn't a supported configuration. If you want 3Mbps of bandwidth for a logical frame-relay connection, you'll want to look at Multilink Frame Relay. Info found here:
The benefit of MLPPP is to combine multiple connections and treat them as a single physical pipe. This is done during the LCP negotiation process where one router indicates to the router on the other end that it's willing to combine multiple connections to form a single physical connection. MLPPP over frame works on the same concept.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.