Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Frame relay T1 module for a 7206-VXR router.

I have a frame relay T1 connected to a T1-CSU/DSU WIC (WIC-1DSU-T1) in a 3620 router right now. I have that frame T1 carved up into several 64kbps point-to-point DLCIs right now.

I need to move that T1, along with the same config, over to a 7206-VXR NP-300 router (I'm de-commisioning the 3620 router). What module do I need for that router?

I have a 4-port multi-channel T1/PRI (PA-MC-4T1) I can put in the 7206 --- will that work?

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Frame relay T1 module for a 7206-VXR router.

G'day,

Yes, you can certainly use that in a 7206-VXR. The card is a multichannel T1 card, which will support channelized interfaces in the same way you are using your T1 on your 3620.

Hope that helps - pls rate the post if it does.

Regards,

Paresh.

1 REPLY
Purple

Re: Frame relay T1 module for a 7206-VXR router.

G'day,

Yes, you can certainly use that in a 7206-VXR. The card is a multichannel T1 card, which will support channelized interfaces in the same way you are using your T1 on your 3620.

Hope that helps - pls rate the post if it does.

Regards,

Paresh.

168
Views
0
Helpful
1
Replies
CreatePlease to create content