Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Frame-relay traffic-shaping

Frame Relay rate limiting :

·Maximum throughput is 128kbps

·During congestion, your provider will mark any traffic in excess of 48kbps as discard eligible,

Make sure your throughput changes accordingly, based upon BECNsreceived, only.

·Your token bucket interval is 125 ms

Config :

map-class frame-relay CIR

frame-relay adaptive-shaping becn

frame-relay cir 128000

frame-relay bc 16000

frame-relay mincir 48000

interface serial 0/0

frame-relay class CIR

frame-relay traffic-shaping

All the gurus, do you think mine config is correct according to the requirement ? Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Frame-relay traffic-shaping

Looks good. I copied and pasted your config in a router and here is the PVC output.

Shaping adapts to BECN

pvc create time 1d18h, last time pvc status changed 1d18h

cir 128000 bc 16000 be 0 byte limit 2000 interval 125

mincir 48000 byte increment 2000 Adaptive Shaping BECN

HTH,

__

Edison.

1 REPLY
Hall of Fame Super Bronze

Re: Frame-relay traffic-shaping

Looks good. I copied and pasted your config in a router and here is the PVC output.

Shaping adapts to BECN

pvc create time 1d18h, last time pvc status changed 1d18h

cir 128000 bc 16000 be 0 byte limit 2000 interval 125

mincir 48000 byte increment 2000 Adaptive Shaping BECN

HTH,

__

Edison.

88
Views
0
Helpful
1
Replies
CreatePlease to create content