Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame Relay Traffic Shaping

Hi all,

I have an issue where I will have to change the traffic shaping parameters. This will be done off hours, but I am wondering what the best practice for this is. Should I edit the current map-class or create another map-class and swap out the interface configuration. Here is the configuration I will be changing.

Change from:

map-class frame-relay shapeforT1

frame-relay cir 768000

frame-relay bc 7680

frame-relay be 0

service-policy output IPFRCOS

Change to:

map-class frame-relay shapeforT1

frame-relay cir 729600

frame-relay bc 7296

frame-relay be 0

service-policy output IPFRCOS

Thanks in advance.

2 REPLIES
Hall of Fame Super Bronze

Re: Frame Relay Traffic Shaping

You could edit the current map-class without any problems. I've done it plenty of times.

___

Edison.

New Member

Re: Frame Relay Traffic Shaping

I would just edit the current map, especially if traffic will be low.

112
Views
0
Helpful
2
Replies