Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Frame-Relay Upgrade

Hi,

I had recently requested an upgrade from my service provider on one of my frame-relay site. Is there a way to verify if an upgrade has been done on my pvc?

Regards.

4 REPLIES

Re: Frame-Relay Upgrade

check the input and output packets on the interface.

Re: Frame-Relay Upgrade

HI [Pls RATE if HELPS]

Use the WAN KILLER Tool to TEST the Circuit.

Using the Tool you can PUMP the Traffic to until your requested Bandwidth. Observe the Input & Output rate on the WAN Interface.

Hope I am Informative.

Pls Rate if HELPS

Best Regards,

Guru Prasad R

New Member

Re: Frame-Relay Upgrade

Hi there,

Thanks for the info but appreciate if you can give more details. How can i confirm the speed with the following sample:

48482432 packets input, 1326954085 bytes, 0 no buffer

21114144 packets output, 2743938039 bytes, 0 underruns

Many thanks.

Re: Frame-Relay Upgrade

HI, [Pls Rate if HELPS]

Pleaes execute the below command and paste:

Router#sh int Gi3/3 | i rate

Queueing strategy: fifo

30 second input rate 15582000 bits/sec, 9299 packets/sec

30 second output rate 58686000 bits/sec, 12625 packets/sec

Refer the "INPUT & OUTPUT" Rate value in the output above and they calculated in bits/sec.

Hope I am Informative.

Pls Rate if HELPS

Best Regards,

Guru Prasad R

91
Views
0
Helpful
4
Replies