Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Frame-Relay

How can I tell what the CIR is for a frame-relay circuit?

Is there someplace on the router I can find this information?

Thanks,

  • WAN Routing and Switching
6 REPLIES

Re: Frame-Relay

"One" of the debug frame-relay cmnds output shows CIR, I'm sorry I can't remember which one. We don't use FR here, this is from a previous job. It might be "debug frame-relay lmi" or "deb frame end-to-end"

HTH

Silver

Re: Frame-Relay

sh frame-relay pvc ...

Hope this helps

Regards

Andrea

New Member

Re: Frame-Relay

Hi Andrea,

My "sh frame-relay pvc 51" output is showed below:

Router #sh frame-relay pvc 51

PVC Statistics for interface Serial0 (Frame Relay DTE)

DLCI = 51, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial0.1

input pkts 7658831 output pkts 15805190 in bytes 1740880024

out bytes 935088571 dropped pkts 0 in pkts dropped 0

out pkts dropped 0 out bytes dropped 0

in FECN pkts 838106 in BECN pkts 0 out FECN pkts 0

out BECN pkts 0 in DE pkts 917355 out DE pkts 0

out bcast pkts 77676 out bcast bytes 28274046

5 minute input rate 0 bits/sec, 2 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

pvc create time 7w5d, last time pvc status changed 1w0d

Is it possible see the CIR information if I'm not using map class?

Tks,

Marcelo

Bronze

Re: Frame-Relay

show frame-relay pvc command, or also try show frame-relay ? with various combination

-Minu

Re: Frame-Relay

The command to display the CIR of a PVC is 'show frame-relay map'. However, the CIR would be displayed only if the LMI type is set to Cisco.

Hope that helps!

Sundar

New Member

Re: Frame-Relay

Sundar,

The command to display the CIR of a PVC is "show frame-relay pvc X" where X is the DLCI number, which should be specified to display the CIR, bc, be....

In addition, the LMI type has no relation. This would work with three types of LMIs.

show frame-relay map would only display L3/L2 mappings.

Regards

104
Views
0
Helpful
6
Replies