07-02-2013 12:05 PM - edited 03-12-2019 04:45 PM
Hi,
I have R1-R2 connected by serial link. There are two sub interfaces on each side connecting these two. How do we configure frame relay on these two sub interfaces without disabling keepalive?
Thanks,
Balajee
Solved! Go to Solution.
07-02-2013 01:03 PM
Hi,
just make one router a frame-relay switch:
R1
enable
config t
frame-relay switching
int s1/0
encapsulation frame-relay
frame-relay intf-type dce
no shut
int s1/0.12
ip address 10.0.0.1 255.0.0.0
frame-relay interface-dlci 201
R2
enable
config t
int s1/0
encapsulation frame-relay
no shut
int s1/0.21
ip address 10.0.0.2 255.0.0.0
frame-relay interface-dlci 201
Regards
Alain
Don't forget to rate helpful posts.
07-02-2013 01:03 PM
Hi,
just make one router a frame-relay switch:
R1
enable
config t
frame-relay switching
int s1/0
encapsulation frame-relay
frame-relay intf-type dce
no shut
int s1/0.12
ip address 10.0.0.1 255.0.0.0
frame-relay interface-dlci 201
R2
enable
config t
int s1/0
encapsulation frame-relay
no shut
int s1/0.21
ip address 10.0.0.2 255.0.0.0
frame-relay interface-dlci 201
Regards
Alain
Don't forget to rate helpful posts.
07-18-2013 09:11 AM
I just tried this...it didn't work. Can you please let me know if it works for you?
- Balajee
07-18-2013 09:54 AM
Hi,
sorry I posted the config quickly and forgot something:
for each subinterface you must specify if it is multipoint or point-to-point before you can configure it
int s1/0.12 multipoint or int s1/0.12 point-to-point for example
Regards
Alain
Don't forget to rate helpful posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: