As you have mentioned in the post theres a clear mismatch on the speed part on both the sides.
Can you revert on which module you are connecting this servers NIC and also whether any previous tries carried out on changing the speed and duplex on the server side so as to match the settings on the switch side ?if not pls try to hardcode the same on both the sides and check..
Also are you seeing any errors on the switchport or any logs related to any mismatches either speed or duplex in the switchlog ?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...