Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

fw feature in ios routers

we use one cisco2811 router between two LANs as a firewall (while it contains fw feature)

(C2800NM-ADVSECURITYK9-M), Version 12.4(3g)

in classic firewalls (PIX) we can configure groups : set of computers, then in one rule we can make this group as source or destination.

but using fw feature in this router, i think it is impossible to do this. i must create one rule of each computer.

is there a way to use one group as a source or destination ?

any help?

thanks

1 REPLY

Re: fw feature in ios routers

AFAIK you can not create groups like in the PIX/ASA, however if you look at the zoned-based firewall feature, you can do some grouping.

http://www.cisco.com/en/US/products/sw/secursw/ps1018/products_tech_note09186a00808bc994.shtml

Hope that helps.

243
Views
2
Helpful
1
Replies