08-01-2007 01:55 AM - edited 03-03-2019 06:07 PM
Hi,
I have a LL (2mbps) one end of which is having V.35 o/p and the far(remote) end it is G.703 o/p.These are the o/p from the modem. Would they work with each other....
sample config would be more helpful...
Thanks,
08-01-2007 02:14 AM
Yes, they will work. On the G.703 side, uncer controller configure channel-group with as many timeslots you are given. Beside this there is no special configuration, just a normal serial line like any other.
08-01-2007 02:19 AM
Thanks
I am having smart serial card at V.35 side..
Which of the following would be better for the G.703 side...
VWIC-1MFT-E1
VWIC-1MFT-G703
I would only have just a plain E1 data link
08-01-2007 03:46 AM
VWIC-1MFT-E1 should be fine. The other type is only when you have unframed link running at 2.048 mbps. And even if it is that what you have. MFT-E1 will work anyway, but at 1.948 mbps.
08-01-2007 04:18 AM
Small correction: 31 timeslots is 1.984, not 1.948 Mbps.
Thanks for the rating and good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: