Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

G703 Configuration

how to configure G703 ethernet interface ,in background of this many different locations are connected with one G703 interface, Kindly advice.

3 REPLIES

Re: G703 Configuration

Hi

can you revert on what type of circuit is being subscribed on the G.703 interface ?

regds

Hall of Fame Super Gold

Re: G703 Configuration

Ethernet is not G.703. E1 and T1 are G.703 interfaces, however cisco refers to unframed E1 as G.703.

This is called channelized configuration (propert ITU name is G.704) and is a service that you obtain from you carrier:

controller E1 x/y/z

channel-group 0 timeslots 1

channel-group 1 timeslots 2

interface serial x/y/z:0

ip address ...

hope this helps, please rate post if it does!

Community Member

Re: G703 Configuration

Hi p.bevilacqua

Thank you for your reply.i can little bit understand kindly inform me in little detail, how can distribute the bandwidth with each channel.if you don't mind kindly give me the sample configuration of that type of interface.

160
Views
0
Helpful
3
Replies
CreatePlease to create content