Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

G703/G704

controller E1 x/y/z

channel-group 0 timeslots 1

channel-group 1 timeslots 2

<repeat for all needed channels>

interface serial x/y/z:0

ip address ...

Kindly give me the complete sample configuration of about mention configuration commands.(G703/G704)

4 REPLIES
Cisco Employee

Re: G703/G704

Your question doesn't really make any sense. The config listed above is for framed operation, which is different to G703.

For unframed G703, you use this CLI snytax -

controller e1 0/0/0

channel-group 0 unframed

interface serial 0/0/0:0

ip address ...

This then makes the entire E1 a single channel group.

http://www.cisco.com/en/US/docs/ios/12_1t/12_1t1/feature/guide/dtg703.html

Hall of Fame Super Gold

Re: G703/G704

Paul, Adnan is following up to an answer of mine. He needs info about channelized information.

Adnan, these are all the commands required. If the hardware is a vwic2, you also need "card type E1 ".

New Member

Re: G703/G704

a g703 e1 card vwic2 doesnt need the card type command as it is only an e1 card it is not an e1/t1,hth

Hall of Fame Super Gold

Re: G703/G704

On the other hand, the expensive vwic2 G.703 version is wasted for a channelized application, because it is really made for the unframed application that Paul mentioned before.

202
Views
0
Helpful
4
Replies
CreatePlease login to create content