Hey all. I have a setup where a remote site has 2 routers, each connected to its own circuit/ISP, that have GLB configured for their Inside interfaces. Each router has a separate GRE tunnel (terminating outside interfaces) established to the single headend VPN router (2 tunnel interfaces here) and I am runnign EIGRP between the headend router and to each remote router.
Router A ++++++++++++ GRE Tunnel0
10.10.10.2/24
+
+
GLB
10.10.10.1/24
+
+
Router B ++++++++++ GRE Tunnel1
10.10.10.3/24
On my headend router I am learning 10.10.10.0/24 from both Router A and B at equal cost. I want to utilize both tunnels for load sharing. I have no problems reaching 10.10.10.3 or their VIP 10.10.10.1 or anyone on 10.10.10.0/24 but not the inside interface of Router A 10.10.10.2. Can anyone think of off the top of their head why this is happening? When I do a show ip route for 10.10.10.2 or 10.10.10.0/24 on the headend vpn router its preferring the tunnel to Router B. Could this be a problem somehow?