You could just remove the load-balancing and it will run like HSRP. All traffic will follow a single path until it fails.
Calling this "load balancing" is not the best name. Host balancing may be a little better.
All this does is control which mac address it responds to a users ARP with. The weight is just a number as related to other members of the group it does not actually look at traffic passing the router.
Now in you case I can't see how this will work. There is only a single host, your firewall, it would only do the ARP once and then should continue to use that mac for hours. Unless the ARP timeout is set very short on the firewall it should only send traffic to one or the other and only change maybe every coupld of hours
in this case I would consider to move back to HSRP so that it is a clear Active / Standby situation.
You have only one client the FW there's no sense in using GLBP here as explained by Tim.
In GLBP you may provide a weighted load balancing:
have a weight of 80 on 3845 and a weight of 20 on 3640.
In this way 4 of 5 flows should be serviced by the 3845 and only 1 of 5 by 3640.
But be aware that a single IP flow will go through only one router at a given time.
I think you shouldn't expect a per packet load-balancing. So the percentages are true on long time windows but in a few seconds it depends which router is serving the alive flows and if they are high volume.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.