Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

GLBP

hi,

I have 2 routers,

2651 & 2811 configured with GLBP with following configs.

topology is like

ISPA---R1---SW---R2---ISPB

||

PIX515---Core

(but below config works for 3-4 mins after arp is build it stops working..) Any help

2651

----

interface FastEthernet0/0

ip address 192.168.2.2 255.255.255.0

duplex auto

speed auto

glbp 10 ip 192.168.2.1

glbp 10 preempt delay minimum 5

glbp 10 weighting 110 lower 90 upper 100

glbp 10 load-balancing weighted

glbp 10 weighting track 100 decrement 5

glbp 10 weighting track 101 decrement 5

glbp 10 forwarder preempt delay minimum 10

2811

----

interface FastEthernet0/0

ip address 192.168.2.3 255.255.255.0

duplex auto

speed auto

no cdp enable

glbp 10 ip 192.168.2.1

glbp 10 preempt delay minimum 5

glbp 10 weighting 110 lower 90 upper 100

glbp 10 load-balancing weighted

glbp 10 weighting track 100 decrement 5

glbp 10 weighting track 101 decrement 5

glbp 10 forwarder preempt delay minimum 10

1 REPLY
New Member

Re: GLBP

The PIX 515/switch aren't whining about duplicate arp entries are they?

139
Views
0
Helpful
1
Replies
CreatePlease to create content