Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

going from 12.3 to 12.4 on 1721 with Frame Relay

I am going to update a 1721 router from 12.3 12.4(16b) and their is a command in the frame realy Virtual-Template that gets dropped I think it doesn't matter but want to make sure. the command is the "ppp ipcp route default" below is the Virtual Template configuration. Any Thoughts...

interface Virtual-Template1

ip address negotiated

ip nat outside

ip virtual-reassembly

ppp chap hostname xxxxxxxxx

ppp chap password xxx

ppp ipcp dns request

ppp ipcp route default

ppp ipcp address accept

1 REPLY
Hall of Fame Super Silver

Re: going from 12.3 to 12.4 on 1721 with Frame Relay

Hello Bob,

you are doing PPP over Frame-Relay.

first idea:

the command could be hidden by a change in defaults with the new release so you don't see it but it is still effective

second thought:

you can configure a default static route in global config using the virtual-template as outgoing interface to get a similar result

see

http://www.cisco.com/en/US/docs/ios/dial/command/reference/dia_p1.html#wp1014725

This command allows a PPP virtual template to dynamically add a default route pointing to the virtual access interface created by the virtual template.

A customer premises equipment (CPE) router with PPP over an ATM or Frame Relay connection can access the Internet without turning on any other routing.

So if you are providing a default route in another way or using any form of dynamic routing over the PPP link I agree it will not be a problem.

Hope to help

Giuseppe

162
Views
0
Helpful
1
Replies