Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

got a lot of ip address 0.0.0.0 from command "show cable host access-group"

hi,

i issued command " show cable host access-group" at ubr 10012 and found a lot of cpe with ip address 0.0.0.0. i use the command( clear cable host xxx) to remove 0.0.0.0 entry. But dose anyone know the reason why ? how to remove it more efficiency ?

best regards.

fred.

uBR-10K#show cable host access-group

0016.cbf6.1e7f 0.0.0.0 host

0017.4239.655a 0.0.0.0 host

00e0.0609.0038 219.71.203.210 host

0002.8adf.de7c 0.0.0.0 host

000c.6e64.a4f9 0.0.0.0 host

0030.0403.fd5d 219.71.219.37 host

0090.0b04.2ae2 219.71.244.66 host

0000.0100.5adc 219.71.245.160 host

0009.2ded.d4b7 0.0.0.0 host

000a.7998.591d 0.0.0.0 host

000d.60e4.b091 0.0.0.0 host

0013.0220.3ff7 0.0.0.0 host

0016.4116.9ff1 0.0.0.0 host

0016.ec55.5776 0.0.0.0 host

0018.f35a.8b03 0.0.0.0 host

2 REPLIES
Silver

Re: got a lot of ip address 0.0.0.0 from command "show cable hos

Hi,

I think it shows you default route address.

But you can do one thing, by using Sniffer you can check out MAC addesss -> IP address.

Regards,

Dharmesh Purohit

Silver

Re: got a lot of ip address 0.0.0.0 from command "show cable hos

0.0.0.0 is belongs to source IP address.

Source IP address for the DSG stream. If an asterisk (*) appears as the source IP address, it indicates that the source IP address is 0.0.0.0, which allows any IP address as the source IP address.

http://www.cisco.com/en/US/products/hw/cable/ps2217/products_command_reference_chapter09186a008018981c.html#wp1169868

Regards,

Dharmesh Purohit

136
Views
0
Helpful
2
Replies
CreatePlease to create content