Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

got error message from inserting EHWIC-4ESG in 3925

                   hi,

                       could everyone see the message "%ESWGE_ERR-3-NIOSII_UP_FAIL: NIOSII fails on 0/3/0 ehwic slot" in 3925 ?

                    we install a new module EHWIC-4ESG in 3925 with ios 15.2.2(T1). 3925 couldn't find the module but got error message above.

  • WAN Routing and Switching
Everyone's tags (5)
3 REPLIES
Hall of Fame Super Gold

Re: got error message from inserting EHWIC-4ESG in 3925

I think you need to reboot the router because OIR is not supported.

New Member

Re: got error message from inserting EHWIC-4ESG in 3925

Same error: %ESWGE_ERR-3-NIOSII_UP_FAIL: NIOSII fails on 0/0/0 ehwic slot

Module is already inserted, error message after reload Cisco 2900. IOS 15.1(4)M6.

Cisco Employee

Re: got error message from inserting EHWIC-4ESG in 3925

Hi,

This can be seen when either card or HWIC chassis slot are faulty. I suggest to check the card in another router to verify if the module is faulty.

Kind Regards,
Ivan Shirshin

**Please grade this post if you find it useful.

Kind Regards, Ivan Shirshin **Please grade this post if you find it useful.
1012
Views
0
Helpful
3
Replies