Most of the docs in CCO, does not state anything about GRE tunnel on 4948's, which means even though the commands are supported on the 4948 (which we can check with some test 4948's), Cisco will not support the technology in these boxes.. I have heard that the 4948's do support GRE tunnels, and is switched on software.. NO hardware switching available. Hence the number of tunnels might be really less and if it increases, it can increase the CPU processing of the switch.. Anyway, the 4948 switch was not designed for taking such connections, and it is really in for guys who want good backplane on server farm !!!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...