GRS fail
Hello everyone,
I have a problem that my active PRP was fail with leaving this log below
" SEC 8:.Mar 2 12:51:22: %MBUS-6-FAILEDPEER: Failed peer RP in slot 7 reason peer: pri heartbeat t/o "
My Question is that if I get this kind of logs how can I suspect whether it's hardware fail or software,
and next time, if I get the log again, what should I check?
Do you have any commands to investigate this fail?
If so, Pleas let me know
Detail information is like below :
SEC 8:50w5d: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:1y2w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:1y12w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:1y12w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:1y32w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:1y36w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:2y6w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:2y20w: Not all config may be removed and may reappear after reactivating the sub-interface
SEC 8:2y21w: Not all config may be removed and may reappear after reactivating the sub-interface
##
SEC 8:.Mar 2 12:51:22: %MBUS-6-FAILEDPEER: Failed peer RP in slot 7 reason peer: pri heartbeat t/o
SEC 8:.Mar 2 12:51:22: %RP-5-NEWPRIMARY: Switchover to new RP
.Mar 2 12:51:23: %FIB-4-FIBNULLIDB: Missing idb for fibidb ATM2/0.14 (if_number 63).
-Traceback= 1DB4E8 161E40 177338 178560 582EDC 583400 58419C 5842EC 584500 57F958 582BFC 2B14EC
.Mar 2 12:51:24: %MBUS-6-RP_STATUS: RP in Slot 8 Mode = MBUS Active
.Mar 2 12:51:30: %MBUS-6-FABCONFIG: Switch Cards 0x1F (bitmask) Primary Clock is CSC_1 Fabric Clock is Redundant
Bandwidth Mode : 10Gbps Bandwidth
##
Mar 22 10:35:49: %SONET-4-ALARM: ATM4/2: ~SLOF ~SLOS ~LAIS LRDI ~PAIS PRDI ~PLOP
Mar 22 10:35:59: %SONET-4-ALARM: ATM4/2: ~SLOF ~SLOS ~LAIS LRDI ~PAIS PRDI ~PLOP
Mar 22 10:35:59: %SONET-4-ALARM: ATM4/2: ~SLOF ~SLOS ~LAIS ~LRDI ~PAIS ~PRDI ~PLOP
GSR_B# sh redundancy
Redundant System Information :
------------------------------
Available system uptime = 4 years, 42 weeks, 4 days, 23 hours, 28 minutes, 43 seconds
Switchovers system experienced = 3
Standby failures = 0
Last switchover reason = active unit failed
Hardware Mode = Duplex
Configured Redundancy Mode = SSO (Stateful Switchover)
Operating Redundancy Mode = SSO (Stateful Switchover)
Maintenance Mode = Disabled
Communications = Down Reason: Simplex mode
Current Processor Information :
-------------------------------
Active Location = slot 8
Current Software state = ACTIVE
Uptime in current state = 4 weeks, 2 days, 1 hour, 27 minutes, 51 seconds
Image Version = Cisco Internetwork Operating System Software
IOS (tm) GS Software (C12KPRP-P-M), Version 12.0(30)S2, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Thu 31-Mar-05 13:29 by pwade
BOOT = disk0:c12kprp-p-mz.120-30.S2.bin,1;
CONFIG_FILE =
BOOTLDR =
Configuration register = 0x2102
Peer (slot: unavailable) information is not available because it is in 'DISABLED' state
GSR_B# sh context
GSR_B# sh context ?
all show all context info for all slots
slot specify a slot for which to show context information
summary display list of context information available
| Output modifiers
<cr>
GSR_B# sh context slot 7
GSR_B#sh gsr slot 7
SLOT STATE TRACE TABLE -- Slot 7 (Current Time is 151982313.864)
+-----------------------------------------------------------------------
| Timestamp Pid State Event Flags
+-----------------------------------------------------------------------
0.944 3 ABSENT EV_NULL
2.284 34 ACTV RP EV_RP_DEDUCE_PRIMARY
149376152.332 31 RP RDY EV_RP_INSTANTIATE
