How would I know if the Cisco 12016 Router can still handle the full internet route from a new IPL and if the router can still handle the load? What particular show command should I use to verify that the router is still capable to handle this?
The current setup is using a GRP with an IOS Version 12.0(31)S4.
SLOT 2 (RP/LC 2 ): Route Processor
MAIN: type 19, 800-2427-02 rev C0
HW config: 0x00 SW key: FF-FF-FF
PCA: 73-2170-06 rev B0 ver 5
Design Release 1.5 S/N XXXXXXXXX
MBUS: MBUS Agent (1) 73-2146-07 rev B0 dev 0
HW version 1.2 S/N XXXXXXXXX
Test hist: 0xFF RMA#: FF-FF-FF RMA hist: 0xFF
DIAG: Test count: 0xFFFFFFFF Test results: 0xFFFFFFFF
FRU: Linecard/Module: GRP-B=
Route Memory: MEM-GRP-512=
MBUS Agent Software version 1.117 (RAM) (ROM version is 2.67)
ROM Monitor version 2.2
Primary clock is CSC 1
Board State is IOS Running ACTIVE (ACTV RP )
Insertion time: 00:01:01 (3y43w ago)
DRAM size: 536870912 bytes
Is there a particular command that would show me how many memory it is currently using for routes? If a new IPL will be included would it still write new routes or just update the existing routes on the router?
Thanks for your responses. Would just like to confirm this because currently as per checking the logs from the router, the free memory is 149896320. 143 MB is still free. The BGP is using around 80 MB. In your current setup are you also using a 512MB or 1G? I'm still checking if our current setup could handle the new routes knowing that there is only 143MB free.
Router#show process memory | inc Free Processor Pool Total: 453026368 Used: 303130048 Free: 149896320 Fast Pool Total: 131072 Used: 102128 Free: 28944 PID TTY Allocated Freed Holding Getbufs Retbufs Process
Router#show ip bgp sum | inc total bytes BGP using 83936716 total bytes of memory
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.