Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Have anyone used HWIC-4T ?

I would like to enquire on above mentioned product. As I believe it is mentioned this high speed wan interface card has 4 serial ports which can support maximum 8Mbits/sec EACH port. That would mean total of 32MBits/sec.

1) Can I confirm if I can make use of each port with 8Mbits each to total 32Mbit/sec and this supported by 2821 backplane?

2) What is the bandwidth option I have? Example say if I would like to have 10Mbit wan link, can I install 8Mbit on serial0 and 2Mbit on serial1 ? Is there bandwidth increment patterns on each serial?

3) This serial ports I believe uses the same types of cable like for WIC-2T. Can I confirm on that? Would I be able to use V.35 solution and subscribe Lease Line BW accordingly from telco?

Any other limitation ?

1 REPLY

Re: Have anyone used HWIC-4T ?

Hi

1) As per the datasheet it does supports 8Mbps per port do refer this link for the same.

http://www.cisco.com/en/US/products/ps5949/products_qanda_item0900aecd80274424.shtml

3) Also the ports are smartserial similar to WIC-2T.

HWIC-4T, HWIC-4A/S Smart Serial ..

http://www.cisco.com/en/US/products/ps5949/products_data_sheet0900aecd80274416.html

regds

142
Views
0
Helpful
1
Replies
CreatePlease to create content