Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

have problem switch 6509

Dear All,

I had switch cisco ws-c6509-E and have module ws-x6148A-GE-TX 48-port 10/100/1000 Base-TGE.On port g4/9 after i

shut down interface and no shut agian,it show message below:

HQ-6509(config-if)#int g4/9

HQ-6509(config-if)#shu

HQ-6509(config-if)#no shut

HQ-6509(config-if)#

00:44:03: %PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state

00:44:03: %PM-SP-STDBY-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state

HQ-6509(config-if)#

what's going on?

Note:On port Gi4/9 connect to my pc,don't

link connection.

Best Regards,

join

2 REPLIES

Re: have problem switch 6509

Hi,

AFAIK there is a physical error on this port, as the diagnostics provide hardware-specific fault-detection.

HTH,

Mohammed Mahmoud.

New Member

Re: have problem switch 6509

Dear Mohammed ,

This problem,Can i fix it by myself?

Or need to send to factory?

Best Regards,

Join

447
Views
0
Helpful
2
Replies