Have you ever had to implement jumbo frames WAN T1 connections?
How would it work on TDM circuits? If I configure MTU 1700 on a T1 Serial interface, does the Access supplier also need to configure it or can I just configure it on my Cisco Routers only? I'm trying to understand if the Supplier is required to configure it also or not? I also have Ethernet WAN connections and want to understand the same; does the Access Supplier need to configure their devices MTU or can it just be configured on the connecting CPE routers to work?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...