having trouble getting output in telnet session for CSR1000v running on ESX 5.5
having trouble getting output in telnet session for CSR1000v running on ESX 5.5, I have followed docs but cant seem to get output, output works on console within the esx host via vsphere client, but cant seem to get any output in telnet session even though connection shows as established. Any ideas on how to resolve this, Im sure this may be nothing major.
If the connection was not allowed crt would show 'connection refused'. In your case the green symbol indicating it is connected. How odd...
OK, so do this... telnet to the CSR1Kv (even though you don't see anything), and then log on to the console and do 'show user' to see if your connecting IP appears there.
Also, I know this sounds a little dumb, but hopefully we have the font in crt in a different colour to the background.
I guess if this does not work, then try to enable SSH which is probably better in general. Last resort would be to try and re-install the CSR1Kv, I just installed one on ESX5.5, both telnet and ssh seem to work with securecrt.
Please rate useful posts & remember to mark any solved questions as answered. Thank you.
Thanks for your assistance, the error was that i didnt select serial console in initial stages it was on VM console, I deleted and recreated routers selecting serial console upon inital boot up and it was able to work, thanks.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.