Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HDLC Keepalive

Hi

I checked link point-to-point HDLC between router A and router B, i saw Line protocol on router B down but on router A is normally then i debug serial interface command on both router to see keepalive messages . I found some question about output keepalive message on router A that is:

Mar 22 2006 Serial0/0: HDLC myseq 6550, mineseen 774091*,yourseen 86413, line up

Mar 22 2006 Serial0/0: HDLC myseq 6551, mineseen 774091*,yourseen 86414, line up

From the output keepalive on router A , why router A not detect the link down ?

Thanks

1 REPLY
Purple

Re: HDLC Keepalive

It could be possible that you have one-way traffic where traffic from Router B is getting to Router A but traffic from router A is not getting to router B...

You might want to check your cabling

Hope that helps - pls rate the post if it does.

Paresh

146
Views
0
Helpful
1
Replies
CreatePlease to create content