I tried to test a dsl connection between two 837 routers back to back but did not succeded even the commande dsl equipment type cannot appear in the command prompt of the int atm0, I changed and used one 2811 with hwic adsl card but encountred same problem, the first question is this kind of configuration dowable between 837 routers and between 837 to 2811 with adsl card and the second question how could we change the equipment type from CPE to CO on these routers
There is no specific configuration guide for setting up a back-to-back connection for DSL. You would most likely have to set one to "dsl equipment-type co" and the other to cpe. also one thing t obe noted is that the distance between the two routers
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...