Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HELP I mistyped the confreg variable in ROMMON

I typed confreg 0x2124 and reset my 2811 and now the characters are not recognizable. How do I undo this mistake?

8 REPLIES
Silver

Re: HELP I mistyped the confreg variable in ROMMON

in 0x2124 mode console speed is 19200 so select speed 19200 instead of 9600 in hyperteminal.

Then you can reset it again.

New Member

Re: HELP I mistyped the confreg variable in ROMMON

that was it. Thanks..

New Member

Re: HELP I mistyped the confreg variable in ROMMON

I typed 0x21142 in my Cisco 2811 confreg,

do you know the solution?


Thanks

The output shows nothing but CCCCCCCC (but the C is in the French version with the comma under the letter C).

New Member

Re: HELP I mistyped the confreg variable in ROMMON

Solution found:

Baud rate = 2400.

New Member

I'll need your help please!!I

I'll need your help please!!

I mistyled the confreg as: 0x1242


Please suggest solution.

Regards,

SachinKotian

New Member

Hi Viyuan700I'll need your

Hi Viyuan700

I'll need your help please!!

I mistyled the confreg as: 0x1242


Please suggest solution.

Regards,

SachinKotian

Silver

Hi Sachin,Please check the

Hi Sachin,

Please check the link below and had the solution. As per them you need to set Baud Rate to 1200.

 

https://supportforums.cisco.com/discussion/11593861/cisco-2600-router-confreg-1242

 

New Member

Hi Viyuan700 ..  thankyou ..

Hi Viyuan700 .. 

 

thankyou .. :) this worked.

1371
Views
5
Helpful
8
Replies
CreatePlease to create content