HELP QUICK! 6500 reload

[gavin.mckee]

Hi,

I am upgrading my sup32 from Hyrbrid to native, and am following the guide:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml#conv_32

When i issue the reload command after changing the config register value to 0x0 i get the following message:

Reload to tge ROM Monitor only allowed from console line unless the conf register boot bits are non zero.

How do I get the router to reload in monitor mode?

Help well rated

[rkhalil]

put confreg 0x2102

or use break sequence for rommon and put confreg 0x2102

--

Regards,

Raul

(Please rate helpful posts)

[gavin.mckee]

I did this and it broke out of session 16

now I can't get on to the MSFC at all

when I do session 16 I get unable to tunnel to session 16

Am i in big trouble now?

[rkhalil]

enter from console of msfc and review your config.