Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

HELP QUICK! 6500 reload

Hi,

I am upgrading my sup32 from Hyrbrid to native, and am following the guide:

http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008015bfa6.shtml#conv_32

When i issue the reload command after changing the config register value to 0x0 i get the following message:

Reload to tge ROM Monitor only allowed from console line unless the conf register boot bits are non zero.

How do I get the router to reload in monitor mode?

Help well rated

3 REPLIES
New Member

Re: HELP QUICK! 6500 reload

put confreg 0x2102

or use break sequence for rommon and put confreg 0x2102

--

Regards,

Raul

(Please rate helpful posts)

New Member

Re: HELP QUICK! 6500 reload

I did this and it broke out of session 16

now I can't get on to the MSFC at all

when I do session 16 I get unable to tunnel to session 16

Am i in big trouble now?

New Member

Re: HELP QUICK! 6500 reload

enter from console of msfc and review your config.

536
Views
0
Helpful
3
Replies
CreatePlease to create content