Thank you in advanced for helping me with this issue.
We are moving from a Cisco Small Business Router SA520 to a 1941W. We have a static ip address and used the basic CP Express Wizard setup wizard. I then used CP normail edition entered the ip address of the external connect on g0/0 and the internal lan on 0/1, easy enough. We then configured the NAT but still can not get outside access.
The only configuring from the isp (comcast business internet) and the orginal SA520 router that I could not find any to enter in this router is the "Default Gateway"........... is this hidden? or am I just lost
Re: HELP with 1941 Router setup and gateway config
I am not sure that I understand your question, and part of that may be because I am not familiar with the SA520. I am guessing that you are looking for how to set the default gateway for the router. On the 1941 that is usually done by configuring a static default route. It would look something like this:
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...