We recently purchased a Cisco 2921 router to be our edge device for a small satellite office (24 users). In addition, to the router we purchased a vwic3-2mft-t1/e1 module. Now the surprise, we ordered a bonded T1, I thought we were getting frame-relay circuits from Verizon, but someone ordered a 3M IMA circuit. I am new to configuring serial connections, and had planned out a frame-relay configuration. With that said, I have the following questions:
1. Can I setup a working serial connection to Verizon using the installed ATM circuit and the 2921 and vwic3-2mft-t1/e1 card I have? If not, what do I need in conjunction with the 2921?
2. With the frame-relay configuration, I enable controllers, configured the MFR interface and sub-interface, and serials. How much different is setting up serial ATM connections? Can anyone post a two port (two T1s bonded) example.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.