help with 7600 router log message ETH_SPA_MAC-DFC1-6-INTR_BURST
can anybody shed some light on this error message:
%ETH_SPA_MAC-DFC1-6-INTR_BURST: Interrupts from MAC have crossed burst limit of 10 in 1000 msec for port 1/1/3
This is happening occasionaly, but the problem is this part "port 1/1/3" because there is no such port/interface on this router... I presume this is talking about some internal port or something - but I cannot find the explanation anywhere.
Only thing I have found is in ASR documentation, there is almost identical message only it does not contain "DCF1" (obviously), but some integer. Explanation there is that I should check interface configuration or receive signal characteristics on the transport path or XFP used... But which interface?? I cannot find to which physical interface this error is related to...
Does anybody know a hardware documentation where these "ports" are identified?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...