I have a problem in my network regarding a backup router, i have configured the frame relay successfully using sub interface method on 2 other routers and they ping each other fine. I cannot get the backup router to ping and i cannot get the server 5 to ping the rest of the network.
Below is what i have been tasked to do and i really could do with some help as im now stuck after trying unsuccessfully
Step 2. ISP B Backup Configuration
On ISP B, configure a static route to the LAN on REMOTE.
On ISP B, configure a static route to the EDGE WAN .
On EDGE, configure a floating static route with an AD=130 to the LAN on REMOTE via ISP B.
On REMOTE, configure a floating default route with an AD=130 to EDGE via ISP B.
On EDGE, the floating static route should not be visible in its routing table. Troubleshoot if necessary.
Edge Router and Remote Router i have setup on a subinterface and they work ok using frame relay through the cloud. I only configured the frame relay subinterfaces on se0/2/0 and se0/0/0.
I cannot ping the ISP B backup from the remote or edge router. The server 5 is able to ping the remote router but is unsuccessful pinging anywere else. What do i need to do it says something about a static route above? Am i not meant to be able to ping the ISP B Backup?
The IP addresses for the Edge router is
The IP adressses for the remote router is
The IP addresses for the ISP backup b Router is
I have also uploaded my packet tracer file, please help in any way that you can.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...