Help with set ip next-hop recursive

[cabrademonte]

I don't understand the  concept of the set ip next-hop  recursive under a route map.  Any help will be very appreciated

[Reza Sharifi]

Hi Luis,

This command is mostly used when you are deploying PBR.

The set ip next-hop command verifies the existence of the next hop specified, and…

• if the next hop exists in the routing table, then the command policy routes the packet to the next hop.

• if the next hop does not exist in the routing table, the command uses the normal routing table to forward the packet.

Have a look at this document for more info:

http://www.cisco.com/en/US/tech/tk364/technologies_configuration_example09186a00801f3b54.shtml#casetwo

HTH

Reza

[cabrademonte]

Thanks a lot.

[wang baojun]

hello,

i have wrote a blog for this title yesterday , seem will help you to understand.

http://blog.sina.com.cn/s/blog_6479d7c50100k07k.html