Guys we have two routers 2821 which is connected to a layer three switch (which has many routes) now the swicth is nortel one which doesnt support ospf or eigrp......all we can do is static routing....now sattic routes are getting redistributed into BGP on cisco routers note both routers are going to one service provider....now if i config HSRP and track the ethernet links which goes to routers but even if the link get broken those static routes will still remian present in router one though the lan will shift the traffic to router 2.....so traffic will be again coming back from 1st router.....guys can someone please help how to do this
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...