Looking at the attached txt file, the highest recorded util is IP input (21%). It could be a false alarm, which I am not sure. It is good if you escalate this to your local vendor and have a TAC case open. Just in case.
What are you running on the router. Are your DHCP scopes on a separate router/server? You are using it as a VTP Server are you? What is the role of this router? It is always a pleasure to help out but information is needed.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...