Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

High input discard rate on interface sc0.

Hi,

I am getting this error on my 6509 sw, any idea ?

"High input discard rate on interface sc0. The inDiscardRateState transitioned from NOMINAL to HIGH due to a measured value of 1.000322684737012, which is between the lower bound of 1.0 and the upper bound of 100.0. The date and time of the measurement is 2009-02-02T19:37:51.797+0000.

High input discard rate on interface sc0. The inDiscardRateState transitioned from NOMINAL to HIGH due to a measured value of 1.000322684737012, which is between the lower bound of 1.0 and the upper bound of 100.0. The date and time of the measurement is 2009-02-02T19:37:51.797+0000."

Regards,

  • WAN Routing and Switching
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Re: High input discard rate on interface sc0.

Hello Mohammed,

one or few packets have been discarded on management interface sc0 going over the lower threshold.

This should be a simple notification if you can still reach and manage the device you can ignore it.

Hope to help

Giuseppe

2 REPLIES
Hall of Fame Super Silver

Re: High input discard rate on interface sc0.

Hello Mohammed,

one or few packets have been discarded on management interface sc0 going over the lower threshold.

This should be a simple notification if you can still reach and manage the device you can ignore it.

Hope to help

Giuseppe

New Member

Re: High input discard rate on interface sc0.

Thanks

Giuseppe once again.

Regards,

662
Views
0
Helpful
2
Replies
This widget could not be displayed.