Hi, i would try a trace route and see if you can detect where the packets are being lost. Also and extended ping might be helpful, type "ping" and then press enter and fill in the prompts, aslo check speed and duplex on both ends. HTH
Target IP address: 2.222.xxx.xxxx
Repeat count :
Datagram size :
Timeout in seconds :
Extended commands [n]: y
Source address or interface: 2.222.xxx.xxx
Type of service :
Set DF bit in IP header? [no]:
Validate reply data? [no]:
Data pattern [0xABCD]:
Loose, Strict, Record, Timestamp, Verbose[none]:
Sweep range of sizes [n]:
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 184.108.40.206, timeout is 2 seconds:
Packet sent with a source address of 2.222.xxx.xxx
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...