You don't look at the ATM protocol. You look at your router. If you want a modem that will support 100 Mbps, then a small router like 890 (as an example) won't support this speed.
You need to have a big router, like a 3945 to support 100 Mbps. That is, of course, you can find an EHWIC card which will support vectoring. Currently, there's no Cisco modules available to support vectoring. Don't know when it'll come out. I guess Cisco is still listening out to see if it's worthwhile developing something like this.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...