Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Host using static nat, but attempting to send all internet traffic out overload NAT

I have a static nat for a video conferencing host (polycom)    When I attempt to send out traffic, it appears as if it's coming from the overload nat address rather than the static nat it has. 

IE

Static NAT   45.3.18.211

Overload NAT: 45.3.18.194   I have a /26 range on the outside.

What might cause this?   Any rules I should check for?

Everyone's tags (4)
1 REPLY
Cisco Employee

Re: Host using static nat, but attempting to send all internet t

It may help if you include the relevant nat configs...

( "show run | i ip nat" and any acl's or route-maps you have referenced in those statements).

You could potentially use an acl on the overload to deny the polycom source address, and permit everything else.

I would give this a try if you are sure that your traffic from that host is being overloaded.

Rob

356
Views
0
Helpful
1
Replies
CreatePlease login to create content