Thanks. Most of the projects that i handle i will be doing a lot of hotstagin and involved testing serial ports n cables. This is the reason i would like to understand whether hot pluggin of cables is allowed in serial ports?
as mentioned earlier by Prem, you can switch off external csu/dsu and also you can shut the serial interface of router and then plug the cable to the serial interface. once done you can then switch on csu/dsu and no shut serial interface.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...