Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

hot swappable interface in a 7513 router

hi,

i have a channel attached 7513 router, which has the following interfaces inserted:

cisco RSP2 (R4700) processor with 131072K/2072K bytes of memory.

R4700 CPU at 100Mhz, Implementation 33, Rev 1.0

Last reset from power-on

G.703/E1 software, Version 1.0.

G.703/JT2 software, Version 1.0.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

Bridging software.

TN3270 Emulation software.

Chassis Interface.

1 CIP2 controller (2 IBM Channels).

3 VIP2 controllers (2 FastEthernet)(8 Ethernet)(8 Serial)(4 T1)(4 Token Ring).

8 Ethernet/IEEE 802.3 interface(s)

2 FastEthernet/IEEE 802.3 interface(s)

4 Token Ring/IEEE 802.5 interface(s)

8 Serial network interface(s)

2 IBM channel interface(s)

123K bytes of non-volatile configuration memory.

Slot 1:

Physical slot 1, ~physical slot 0xE, logical slot 1, CBus 0

Microcode Status 0x4

Master Enable, LED, WCS Loaded

Board is analyzed

Pending I/O Status: None

EEPROM format version 1

VIP2 controller, HW rev 2.10, board revision B0

Serial number: 08218518 Part number: 73-1684-04

Test history: 0x00 RMA number: 00-00-00

Flags: cisco 7000 board; 7500 compatible

EEPROM contents (hex):

0x20: 01 15 02 0A 00 7D 67 96 49 06 94 04 00 00 00 00

0x30: 58 00 00 01 00 00 00 00 00 00 00 00 00 00 00 00

Slot database information:

Flags: 0x4 Insertion time: 0x1DC4 (1y28w ago)

Controller Memory Size: 64 MBytes DRAM, 1024 KBytes SRAM

PA Bay 0 Information:

Mx Serial PA, 4 ports

EEPROM format version 1

HW rev 1.10, Board revision A0

Serial number: 08498829 Part number: 73-1577-05

PA Bay 1 Information:

Mx Serial PA, 4 ports

EEPROM format version 1

HW rev 1.10, Board revision A0

Serial number: 09430051 Part number: 73-1577-05

now i have the task to remove the two 4-port Serial cards in slot 1.

is this hot removeable ??

or do i have to switch the router off ?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: hot swappable interface in a 7513 router

You can remove the board while the router is powered on. The board is hot swappable.It will not effect anything.

1 REPLY
Silver

Re: hot swappable interface in a 7513 router

You can remove the board while the router is powered on. The board is hot swappable.It will not effect anything.

128
Views
0
Helpful
1
Replies
CreatePlease to create content