Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How can i do loadbalancing on Router cisco?

Dear All,

I would like to ask you some question that i want to do loadbalancing on Cisco Rouer 1721. the Cisco Router 1721 is internet router. cisco Router 1721 connect to ASA 5510 ( on the wany ASA 5510 we use public ip address) so it make to difficalt to do internet loadbalancing.

My diagram :

ISP-> Router 1721->ASA5510->access switch.

How can i do on this issue?

Best Regards,

Rechard

2 REPLIES

Re: How can i do loadbalancing on Router cisco?

Hi,

Check out the below link for IOS based Loadbalacing between ISP using cisco router

http://www.cisco.com/en/US/tech/tk648/tk361/technologies_configuration_example09186a00808d2b72.shtml

HTH

Regards

Ganesh.H

Re: How can i do loadbalancing on Router cisco?

for basic loadbalncing

you can do it by using equal cost route

i will assume that you have deault static route to the ISP

if you have two ISPs or link fo rhe internets you can configure two static route with the same AD each one point to one of the links ( next hop)

and also you need to consider the NATing if you are doing the nating in the router for te internet traffic

see the bellow document that may help you to understand some concepts and configurations:

https://supportforums.cisco.com/docs/DOC-8313

good lcuk

if helpful Rate

243
Views
0
Helpful
2
Replies