Re: How can I load the max capacity of 10 Gbit ethernet?
Quite difficult. You would have to join two switches via 10 Gbit, and populate each switch with 100 or more of those PCs, then get them transferring bulk data. Or you could use 10 (or more) servers each with 1 Gbit interfaces.
It would be rare indeed for a 10 Gbit link to be overloaded ... only for extreme high density sites. However, there are more advantages to 10 Gig than just the bandwidth. The latency is also lower.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...