Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How do determine which pc's are using up the wan bandwidth ?

Please see the attached screenshot., how do i go about this?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

How do determine which pc's are using up the wan bandwidth ?

i would go closest to the source of the traffic. So, Router 1 at the client side.

4 REPLIES
Gold

How do determine which pc's are using up the wan bandwidth ?

New Member

How do determine which pc's are using up the wan bandwidth ?

Suppose I have:

  Clients -------- switch-------router--------router----------router (netflow enabled) ---------switch---------Servers

In  the above topology with netflow only enbled in the last router. Will i  still be able to monitor which clients are using up bandwidth to the  Servers? Or should I enable netflow on the first router?

Gold

How do determine which pc's are using up the wan bandwidth ?

i would go closest to the source of the traffic. So, Router 1 at the client side.

New Member

How do determine which pc's are using up the wan bandwidth ?

You could configure under the interface

Show ip accounting to check the result

205
Views
0
Helpful
4
Replies