Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

how do I add ATM command?

I need help trying to add this command to a 2811. Can someone tell me what the command is to add it to startup-config?

interface ATM1/0

description 26HCGJxxxxxx

no ip address

ip nbar protocol-discovery

no atm ilmi-keepalive

no scrambling-payload

!

interface ATM1/0.36 point-to-point

description DATA traffic to xxxx Street

bandwidth 1382

ip address 10.xxx.xxx.xxx 255.255.255.252

ip nbar protocol-

pvc 1/36

vbr-rt 1382 1382 1

tx-ring-limit 3

service-policy output Voice

!

!

interface ATM1/1

no ip address

shutdown

no atm ilmi-keepalive

no scrambling-payload

!

interface ATM1/2

no ip address

shutdown

no atm ilmi-keepalive

no scrambling-payload

!

interface ATM1/3

no ip address

shutdown

no atm ilmi-keepalive

no scrambling-payload

1 REPLY

Re: how do I add ATM command?

Friend,

whatever you configure goes into the running configuration.

To have the same copied to your start-up config just do

wr mem or

copy run start

you can view what is there in the start-up config by issuing the command

sh start-up config

HTH

Narayan

92
Views
0
Helpful
1
Replies