Now why they choose these numbers is unclear. These seem kinda big to me but they may be choosing a value that is safe for most conditions.
The only bad thing about making this too high is that you waste memory in your router. Larger values also tend to make your utilization of your underlining circuit more bursty but it depends on your situation if this will cause any issues.
In general you will need more buffers (ie larger burst) when the ratelimit you are tryng to obtain is a lot lower than than the physical speed of the interface.
It is farily easy to see when you set it too low because the show rate command will show packet drop but the transfer rate will be below the limit you configured.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.