Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

How do I enable a WS-X6748-GE-TX

How do I enable a WS-X6748-GE-TX in a 6506 with SUP720 MSFC3A?

3 REPLIES
Hall of Fame Super Blue

Re: How do I enable a WS-X6748-GE-TX

Dan

Not sure what you mean by "enable". The 6500 linecards are hot swappable so you can just insert the card into a spare slot in the chassis and it should be available to configure.

Are you having problems getting the switch to recognise the module ? If so it could be your IOS version.

Jon

New Member

Re: How do I enable a WS-X6748-GE-TX

The module is recognized in the sh Mod, but gets disable by an exception "PM_SCP-SP-1-LCP_FW_ERR: System resetting module 2 to recover from error: Linecard received system exception. Errcode =

2409000001"

Hall of Fame Super Blue

Re: How do I enable a WS-X6748-GE-TX

Dan

You could try reseating the module but if it is recognised initially and there is enough power for it it looks like a hardware fault i'm afraid.

Jon

998
Views
0
Helpful
3
Replies